Technical Resources

Fast Facts

Thermoplastic liners can be mechanically damaged. Please visually inspect rod string and boxes to make sure they are free from sharp edges or corrosion damage.

Minimum API Torque should be followed when making up connections. Avoid special position makeup.

Thermoplastic lined tubular creates an ID restriction; please refer to the Common Oilfield Dimensions chart and drift sizes.

Drifting of connections after makeup is strongly suggested.

Thermoplastic liners are inert to most chemicals and acids.

Hot oiling or hot watering can be performed on thermoplastics with a recommended minimum safety margin of -10°F liner temperature limit to allow room for error in field temperature measurements and uneven heating of fluids.

Thermoplastics do not add strength to the steel. Evaluate structural integrity of the steel tubing before lining and installation.

The unique mechanical bonding process allows the ability to line used tubing.

Remember, liners protect the ID of your tubular. If you start with yellow banded pipe, then in 10 years, you will still have yellow band pipe unless you have an environment that deteriorates the OD of the steel.

Thermoplastic liners can be used in horizontal wells where the pump is set below kick-off point.

Rod guides are not recommended in rod wells.

Thermoplastic liners can be used in wells that are highly deviated, dog legged, or corkscrewed.